Boat Builder Central

All,

Appreciate the feedback, I will check out Rick's videos to get an idea of what he did.

Thanks,

Robert

Hi Folks, I am finally at the stage of installing the internal framing/bulkheads on my TW28 and I need a little guidance / clarification. The plans seem ambiguous when it comes to the frames B - G extending all the way to the bottom of the keel. The side view in sheet #D262/3 show them all extending...

I have viewed many of the posts and pictures of both the 'LUKA' and 'Stoere Meid' and they were part of the inspiration to finally build my boat. I only wished I had started much sooner. I wanted a very economical boat to cruise the Florida keys and island hop the Caribbean (in good weather) with th...

What sander do you have? I currently have a Rigid 6" Orbital sander and Dewalt 1/4 sheet finishing sander Need tape widths to say for sure. The build manual lists the following: Fiberglass seams: Hull seams: all from biaxial tape 2 layers outside, 3 layers inside except for bow, transom and al...

Wow! I appreciate all the info. You are correct in stating that the chines are not prepared, I can't decide on the radius to use or the best way to get it done. I wanted to use a laminate trimmer with a round-over bit, but it might be less than ideal given the >90 degree angles. I never thought abou...

After a few delays I finally started my TW28 build in April of this year. I am at the stage where I am going to start taping and then fiber-glassing the outside of the hull. I am looking for advice/feedback on the layup schedule and tips on the glassing that are specific to the TW28. The hull is mar...