Boat Builder Central

I spent a lot of time fairing. More than I thought it would. I have fair hull, but need to out on my skeg and spray rails. I have cut the pieces for both and was thinking about vacuum bagging them on. Few questions. If I vacuum bag, will it be a lot easier to fair them to the hull? Also, if I use va...

More sanding. After I finish other side, I think I'll be done with the bottom. The side of the bottom I sanded is smooth and I can see an x pattern of sanding marks everywhere. No low spots left. The sides look really good. I think they were last sanded with 40 grit. Should I smear a coat of quickfa...

I was mixing 10 ounces. I see now it was too much to spread. I'll mix a smaller batch.

Can quickfair be thinned a little? Seams like it's getting a little thick after a few minutes.

How do I prevent these waves when I'm pulling the filling board? Seams like I just keep creating more work.

Thanks. That's exactly what I was looking for.

Do you know what the builders name was or was there ever a build thread? I swear I saw some other photos of the boat, but I can't find them now either. It looks like his center console is pushed further back than the plans show. I would also like this as well. Just trying to plan ahead.

Are there anymore pics of this Panga 20 in the forum? I've looked and can't find any?

I'm still learning as well. We will get through the builds together. If I were you, I would start a build thread and document along the way. The thread has provided me a wealth of information.

It's in pg20 ls. It's labeled MW side. These are the two peices I'm talking about. If you cut them and line them up as shown in pic, it provides the correct angle.it should look like the drawing I attached.