AA,Aripeka Angler wrote: ↑Fri Mar 13, 2020 12:58 pm Looks great! I think you are going to meet the deadline.
Just a suggestion, I put a small limber hole in the lower edge of each support to keep the water flowing back.
My original thought was to put a limber hole in the bottom corner but since I decided to cut back the gunwale tops and thus making the supports slightly smaller I didn't have much room to do this. The bottoms of the supports range from 2-1/4" - 1-1/4" so there wasn't much room for the holes. Also, I figured since the bottoms were so small there wouldn't be much an issue with water being held back. Once I get them installed I can always come back and drill holes if need be.
Thanks for the suggestion though!
-Reid