Page 1 of 1
GF-16 Seat Frame Placement
Posted: Wed Jan 13, 2021 9:17 pm
by DaveTN
Just started cutting out parts for my GF16 (first build). Possibly a dumb question but when marking out the locations for the seat frames - do I mark the measurements along the top (straight) sheer and then mark lines 90 degrees to the sheer at these points and align the frames with these lines? I hope this question makes sense.
Cheers!
Re: GF-16 Seat Frame Placement
Posted: Wed Jan 13, 2021 9:52 pm
by TomW1
Dave welcome to the group. Glad you caught the virus.
I have the plans somewhere around the house here, but not sure where. Hopefully one of the other builders will answer shortly. The GF16 is a great boat. Have been out 5 miles in the Gulf of Mexico in it and my buddy used it a lot in the Savannah, GA area for saltwater fishing, even caught a big Tarpon in it.
Tom
Re: GF-16 Seat Frame Placement
Posted: Wed Jan 13, 2021 11:15 pm
by DaveTN
TomW1 wrote: ↑Wed Jan 13, 2021 9:52 pm
Dave welcome to the group. Glad you caught the virus.
I have the plans somewhere around the house here, but not sure where. Hopefully one of the other builders will answer shortly. The GF16 is a great boat. Have been out 5 miles in the Gulf of Mexico in it and my buddy used it a lot in the Savannah, GA area for saltwater fishing, even caught a big Tarpon in it.
Tom
Thanks Tom,
I'm looking forward to the build. If there's any interest I'd be happy to start a thread on the build, at the moment I am busy cutting out all the parts and waiting for my epoxy supplies to arrive.
Cheers,
Dave
Re: GF-16 Seat Frame Placement
Posted: Thu Jan 14, 2021 11:39 am
by piperdown
I'll have to double check to be exact but look at page 1 on the large sheets. It shows it from the baseline IIRC, not the shear.