What's up guys?
I am at it again. I just ordered materials from Reid. I am going to try and have the strong back done tonight.
I have to have this done by late mid June due to a baby on the way that is due July 4th.
LM18
-
- * Bateau Builder *
- Posts: 912
- Joined: Tue Aug 13, 2019 3:02 pm
- Location: VA
Re: LM18
Make it happen, Cap'n!
Re: LM18
I have the same deadline, we can race. I have a slight head start but I took tonight off, should even things out.
Good luck, watching closely.
Good luck, watching closely.
There are only two seasons in Vermont: boating season, and boat-building season.
Completed Paul Butler 14' Clark Fork Drifter
Completed Jacques Mertens FS14LS + 10%, Build Thread
Started Iain Oughtred Tammie Norrie
Completed Paul Butler 14' Clark Fork Drifter
Completed Jacques Mertens FS14LS + 10%, Build Thread
Started Iain Oughtred Tammie Norrie
Re: LM18
Fs14ls, jaysen posted the link. I have a little more than a slight head start but I tend to take the longest possible route through any step so you could well still beat me. I also need to wait for warm weather before I can paint, which is about all I have left.
There are only two seasons in Vermont: boating season, and boat-building season.
Completed Paul Butler 14' Clark Fork Drifter
Completed Jacques Mertens FS14LS + 10%, Build Thread
Started Iain Oughtred Tammie Norrie
Completed Paul Butler 14' Clark Fork Drifter
Completed Jacques Mertens FS14LS + 10%, Build Thread
Started Iain Oughtred Tammie Norrie
-
- Active Poster
- Posts: 346
- Joined: Sun Jun 10, 2018 10:31 pm
- Location: Fort Valley Ga
Re: LM18
lets goooo!
Re: LM18
Good looking boat VT Jeff.
Jeff I have definitely missed you guys!
Maybe JM can chime in on this.
1. Since I have been introduced to pressing a 1 piece cap from a mold. Would it be OK to do it for the LM and glue it in place or does it need be done seperate?
2. I was looking at the plans. I only saw straight sheer round chine and low sheer round chine. Is there an option like the FS18 regular sheer and regular chine?
Jeff I have definitely missed you guys!
Maybe JM can chime in on this.
1. Since I have been introduced to pressing a 1 piece cap from a mold. Would it be OK to do it for the LM and glue it in place or does it need be done seperate?
2. I was looking at the plans. I only saw straight sheer round chine and low sheer round chine. Is there an option like the FS18 regular sheer and regular chine?
Who is online
Users browsing this forum: No registered users and 15 guests