A cool picture of the P21 being launched this year. My new marina does not have a ramp so they picked it up off the trailer and drooped it in the slip for me.
What a beautiful and seaworthy design. We had a absolutely fantastic time with the boat last year and looking forward to a new year of slaughtering fish!
p21 pic
- Cracker Larry
- * Bateau Builder - Expert *
- Posts: 22491
- Joined: Fri Mar 11, 2005 3:39 pm
- Location: Savannah, GA
Re: p21 pic
That is a fine looking boat right there Sweet and salty at the same time
Completed GF12 X 2, GF16, OD18, FS18, GF5, GF18, CL6
"Ships are the nearest things to dreams that hands have ever made." -Robert N. Rose
- topwater
- * Bateau Builder - Expert *
- Posts: 3131
- Joined: Tue Oct 30, 2007 6:27 pm
- Location: Port Charlotte
- Location: Florida
Re: p21 pic
Looks like you have some new bling added on. rod holders on cabin top, trim tabs .
Boat looks awesome
Boat looks awesome
Novi 23 finally launched !
Re: p21 pic
thanks guys!
i did add some bling over the winter. I cut out the old seat boxes and made new larger ones with lots of storage and also extended and lowered the floor in the berth so we can actually sit comfortably in there now. The rocket launcher i made myself. It turned out pretty good. Welding aluminum was neat. I've built a few nice roll cages for cars so i have all the stuff so i figured I'd give it a try. it turned pretty good.
i did add some bling over the winter. I cut out the old seat boxes and made new larger ones with lots of storage and also extended and lowered the floor in the berth so we can actually sit comfortably in there now. The rocket launcher i made myself. It turned out pretty good. Welding aluminum was neat. I've built a few nice roll cages for cars so i have all the stuff so i figured I'd give it a try. it turned pretty good.
- tech_support
- Very Active Poster
- Posts: 12318
- Joined: Wed Dec 31, 1969 7:00 pm
- Location: Vero Beach, FL
- Contact:
Re: p21 pic
You really have one fine boat!
Re: p21 pic
Fastlane,
Your aluminum rocket launcher work is similar to my latest project. I'm welding up an aluminum safety railing to go around a cockpit out of 1" tubing. So I found the piece of equipment interesting that you have attached to your drill press to cut round ends in the tubing. What is it?
George
Edited - Found it, a tube notcher from HF. Nice, it would have made my project much easier. I have a similar tube roller too.
Your aluminum rocket launcher work is similar to my latest project. I'm welding up an aluminum safety railing to go around a cockpit out of 1" tubing. So I found the piece of equipment interesting that you have attached to your drill press to cut round ends in the tubing. What is it?
George
Edited - Found it, a tube notcher from HF. Nice, it would have made my project much easier. I have a similar tube roller too.
George C
Who is online
Users browsing this forum: Ahrefs [Bot] and 6 guests