Had a small issue with a float switch which burned up my bilge pumps. It only burned a couple wires in the bilge area and only the ones that went to the pumps. Anyone got a link to a proper wiring of a boat. I am going to rewire the pumps from the batteries and install new pumps.
Second question since the new float switches are horrible and die after a year does anyone have one they recommend is it really needed.
Boat is a Duracraft Draftmaster full aluminum hull with a tunnel. Trailered everywhere and not kept in water unless I am on her. It has twin 500 gph pumps for bilge and a 1000 gph pump for the livewell.
Any tips would be appreciated. I am very well versed in electrical for home but not so much in DC.
Thanks in advance
Mark.
Boat rewire
-
flattitude 1976
- Frequent Poster
- Posts: 21
- Joined: Mon Jan 26, 2009 2:23 am
- Location: Loxahatchee, Fl
-
NOTHING ELSE MATTERS
- Active Poster
- Posts: 305
- Joined: Thu Mar 11, 2010 11:26 pm
- Location: LONG ISLAND NEW YORK
Who is online
Users browsing this forum: No registered users and 27 guests