Eric's C21

Power Boats only. Please include the boat type in your question.
Jeff
Site Admin
Site Admin
Posts: 8448
Joined: Fri Apr 29, 2016 12:17 pm
Location: Vero Beach

Re: Eric's C21

Post by Jeff »

Eric, again, that is going to be a slick bottom on your boat!! Jeff

Eric1
Very Active Poster
Very Active Poster
Posts: 3072
Joined: Tue Aug 19, 2014 3:17 pm
Location: Spartanburg,S.C.

Re: Eric's C21

Post by Eric1 »

Jeff wrote: Mon Aug 21, 2017 2:15 pm Eric, again, that is going to be a slick bottom on your boat!! Jeff
I'm hoping so. As you can see I just knocked off the spikes and scuffed the surface. As ugly as it is after sanding it feels like a piece of furniture after you Pledge

Fuzz
* Bateau Builder - Expert *
* Bateau Builder - Expert *
Posts: 8939
Joined: Tue Aug 02, 2011 4:23 am
Location: Kasilof, Alaska

Re: Eric's C21

Post by Fuzz »

If the next coat comes out as good as the first one I would call it good and move on. I am pretty sure you will not until you have at least three coats on it and get to sand it at least one more time though :lol:
21 foot times three times is more than 45 foot one time I think :D

User avatar
BB Sig
Very Active Poster
Very Active Poster
Posts: 1751
Joined: Thu Sep 29, 2011 9:20 am
Location: Tallahassee, FL
Contact:

Re: Eric's C21

Post by BB Sig »

You can tell it is slick in the picture. It has a nice shine! I think this is going to be one fast boat with that slick of a hull. The first time you find bottom, I expect you will cry on the inside. :lol:

I predict five coats total... One down, four to go! 8O

Eric1
Very Active Poster
Very Active Poster
Posts: 3072
Joined: Tue Aug 19, 2014 3:17 pm
Location: Spartanburg,S.C.

Re: Eric's C21

Post by Eric1 »

Fuzz wrote: Mon Aug 21, 2017 4:19 pm If the next coat comes out as good as the first one I would call it good and move on. I am pretty sure you will not until you have at least three coats on it and get to sand it at least one more time though :lol:
21 foot times three times is more than 45 foot one time I think :D
Jacques said three because of the way I did strakes. I found a quick way to sand it , so it's not that bad.
Peter Hagenaars brought up a good point too. He thinks I should cover the lower(outer) two strakes all the way.
I may go back and tape them off. After graphite I will have to seal them in plain epoxy so I can paint over them at the waterline though.
It will be a minor nuisance.

I'm surprised you only went with a single coat. I figure your coast is a heck of a lot more rocky than mine.

Eric1
Very Active Poster
Very Active Poster
Posts: 3072
Joined: Tue Aug 19, 2014 3:17 pm
Location: Spartanburg,S.C.

Re: Eric's C21

Post by Eric1 »

BB Sig wrote: Mon Aug 21, 2017 4:32 pm You can tell it is slick in the picture. It has a nice shine! I think this is going to be one fast boat with that slick of a hull. The first time you find bottom, I expect you will cry on the inside. :lol:

I predict five coats total... One down, four to go! 8O
Gosh I hope three get it done. 8O

User avatar
BB Sig
Very Active Poster
Very Active Poster
Posts: 1751
Joined: Thu Sep 29, 2011 9:20 am
Location: Tallahassee, FL
Contact:

Re: Eric's C21

Post by BB Sig »

Eric1 wrote: Mon Aug 21, 2017 4:41 pm
BB Sig wrote: Mon Aug 21, 2017 4:32 pm I predict five coats total... One down, four to go! 8O
Gosh I hope three get it done. 8O
You sanded one coat almost all the way off. :lol: I still count that coat because you put it on. :wink:

Aripeka Angler
* Bateau Builder - Expert *
* Bateau Builder - Expert *
Posts: 6725
Joined: Thu Sep 13, 2007 9:13 pm
Location: Dade City, Florida

Re: Eric's C21

Post by Aripeka Angler »

Very nice job on the graphite bottom paint. :D Looks perfect from here!
Richard
Completed boats...XF20 "Red Alert", Aripeka Angler's Strip Canoe, FS18 “Bare Bones”, GF12
Currently building...PY12 Kayak
If there is magic on this planet, it is contained in water. - Loren Eiseley
Bare Bones build thread...
viewtopic.php?f=12&t=62146

Eric1
Very Active Poster
Very Active Poster
Posts: 3072
Joined: Tue Aug 19, 2014 3:17 pm
Location: Spartanburg,S.C.

Re: Eric's C21

Post by Eric1 »

Aripeka Angler wrote: Mon Aug 21, 2017 6:34 pm Very nice job on the graphite bottom paint. :D Looks perfect from here!
Thanks Buddy. :D

Jeff
Site Admin
Site Admin
Posts: 8448
Joined: Fri Apr 29, 2016 12:17 pm
Location: Vero Beach

Re: Eric's C21

Post by Jeff »

Agree with AA, looks really nice and confident it will finish beautifully!! Jeff

Post Reply

Who is online

Users browsing this forum: Ahrefs [Bot] and 10 guests