Pinhole factory
-
OrangeQuest
- Very Active Poster
- Posts: 3990
- Joined: Tue Aug 28, 2018 1:14 pm
- Location: Houston, Texas
Re: Pinhole factory
Fallguy, I have really learned a lot from you and you posting your failures and your tricks that keeps you from making mistakes, but you don't seem to want to say you have been doing a fantastic job. Which you have been and the results you post show it. Just wish you would listen to your stupid Doctors and slow down sometimes. You become more and more cyborg!
"that it isn't just an ordinary sort of boat. Sometimes it's a Boat, and sometimes it's more of an Accident. It all depends." "Depends on what?" "On whether I'm on the top of it or underneath it."
A. A. Milne-- Winnie the Pooh
A. A. Milne-- Winnie the Pooh
-
Fuzz
- * Bateau Builder - Expert *
- Posts: 9150
- Joined: Tue Aug 02, 2011 4:23 am
- Location: Kasilof, Alaska
Re: Pinhole factory
You guys need to do your sanding here. It was a nice sanding morning of 47f 
-
fallguy1000
- * Bateau Builder - Expert *
- Posts: 10506
- Joined: Tue Jan 12, 2010 12:25 am
Re: Pinhole factory
Well, we turned things around today. Had a good day filling on 45 degrees to prior fill.
Three guys. Filled the entire hull. A few areas were deep fills, but most of the hull looks great.
Sanding tomorrow will be 80 grit.
Three guys. Filled the entire hull. A few areas were deep fills, but most of the hull looks great.
Sanding tomorrow will be 80 grit.
- Attachments
-
Who is online
Users browsing this forum: No registered users and 8 guests