Sharkbait PG20
-
- Frequent Poster
- Posts: 119
- Joined: Sun Oct 21, 2018 9:58 am
- Location: San Antone/Bahamas
Re: Sharkbait PG20
Finished the glass on the other side and tacked down some stringers. I'll get some pics up tomorrow.
-
- Frequent Poster
- Posts: 119
- Joined: Sun Oct 21, 2018 9:58 am
- Location: San Antone/Bahamas
Re: Sharkbait PG20
Stringers glasses in. Slow process as you do a little work and have to wait for drying.
-
- Frequent Poster
- Posts: 119
- Joined: Sun Oct 21, 2018 9:58 am
- Location: San Antone/Bahamas
-
- Frequent Poster
- Posts: 119
- Joined: Sun Oct 21, 2018 9:58 am
- Location: San Antone/Bahamas
-
- Frequent Poster
- Posts: 119
- Joined: Sun Oct 21, 2018 9:58 am
- Location: San Antone/Bahamas
Re: Sharkbait PG20
Got the foam started today. Used 2 gallons. Ordered a third. I'll get some pics up tomorrow.
Re: Sharkbait PG20
Nice progress!!! Jeff
-
- * Bateau Builder *
- Posts: 449
- Joined: Sun Dec 30, 2018 9:09 pm
- Location: Spanish Fort, AL
Re: Sharkbait PG20
Getting the foam in is milestone. Cutting the foam level to the frames was tough for me.
-
- * Bateau Builder - Expert *
- Posts: 8942
- Joined: Tue Aug 02, 2011 4:23 am
- Location: Kasilof, Alaska
Re: Sharkbait PG20
For cutting the foam I used a framers cross cut saw that was long enough to span the stringers. Do not forget you can toss the cut-offs into the next place to be foamed so it is not waisted.
- BrianC
- * Bateau Builder *
- Posts: 376
- Joined: Tue Dec 01, 2015 11:10 am
- Location: Cedar Point, NC
- Contact:
Re: Sharkbait PG20
Nichrome wire and a 12v battery works wonders for foam cutting.FluidDynamic wrote: ↑Fri Jan 08, 2021 11:32 pm Getting the foam in is milestone. Cutting the foam level to the frames was tough for me.
SK14 completed ——— GV15 under construction
"...there is nothing - absolutely nothing - half so much worth doing as simply messing about in boats.”
— The Wind in the Willows — Kenneth Grahame
— The Wind in the Willows — Kenneth Grahame
-
- * Bateau Builder *
- Posts: 449
- Joined: Sun Dec 30, 2018 9:09 pm
- Location: Spanish Fort, AL
Re: Sharkbait PG20
Any progress?
Who is online
Users browsing this forum: Bing [Bot] and 0 guests