FS19 in Sherwood, OR

To help other builders, please list the boat you are building in the Thread Subject -- and to conserve space, please limit your posting to one thread per boat.

Please feel free to use the gallery to display multiple images of your progress.
Post Reply
Jeff
Site Admin
Site Admin
Posts: 8528
Joined: Fri Apr 29, 2016 12:17 pm
Location: Vero Beach

Re: FS19 in Sherwood, OR

Post by Jeff »

Nice progress Scrappy!!!! Jeff
Top
fallguy1000
* Bateau Builder - Expert *
* Bateau Builder - Expert *
Posts: 10506
Joined: Tue Jan 12, 2010 12:25 am

Re: FS19 in Sherwood, OR

Post by fallguy1000 »

Make sure to run a #10-12 bond wire to the tank. They should have a tab for you. That line also goes to deck fill and vent if metal and then to ground bus.

Looking good.
My boat build is here -------->

viewtopic.php?f=12&t=62495
Top
Scrappy
Frequent Poster
Frequent Poster
Posts: 53
Joined: Mon Apr 20, 2020 11:04 am
Location: Sherwood, OR

Re: FS19 in Sherwood, OR

Post by Scrappy »

fallguy1000 wrote: ↑Sun Jul 11, 2021 10:41 am Make sure to run a #10-12 bond wire to the tank. They should have a tab for you. That line also goes to deck fill and vent if metal and then to ground bus.

Looking good.
Copy on the bond wire. Thanks.
Top
Scrappy
Frequent Poster
Frequent Poster
Posts: 53
Joined: Mon Apr 20, 2020 11:04 am
Location: Sherwood, OR

Re: FS19 in Sherwood, OR

Post by Scrappy »

8663

Sole is in but not glued. Totally unacceptable for billiards but not terrible for a boat. There are some high spots in the foam underneath and a few places where the cleats along the hull are too high. I’ll pull the panels out and work on leveling things out a bit more. Also need to install the fuel sender in the tank and make cut outs for cockpit drains and access panels as well as support for the mounts for the cooler seat that will be at the helm.
Top
Post Reply

Return to “Builder's Power Boats”

Who is online

Users browsing this forum: No registered users and 17 guests