GF16 rebuild with center console 25Hp Suzuki

[bernd1]

..from 2013....half speed .....she was a little bit afraid of the acceleration....
https://www.dropbox.com/s/ejvmdepxm5yzr ... 3.wmv?dl=0

[OrangeQuest]

Looking good!

[piperdown]

I know this is a slightly older thread but would you mind sharing a few closer pics of the center console? This is something I'd love to do with my GF16 build.
It appears you were able to keep a hatch in the middle seat?

[bernd1]

Sorry for the late reply - I was offline a lomg time. The first I did: I used cardboards to design the dimensions of my CC. I wanted to have good propertion CC to boat and the max space between the sides and the CC. I will take photos with dimensions the next days . You will then be able to copy or to use as an idea how to construct your own one. I first used a CC-design from here and then I cut the cardboard and decreased with the cutter more and more until I was satisfied. To hold the pieces in place i used duct-tape and zip ties .

Hope it helps you a little bit.

Bye
Bernd

Okay, here is the link to the pictures...

https://www.dropbox.com/sh/ob4lv2gp1qx1 ... pDI9a?dl=0

BTW : I made the CC removable - that means, I used stainless steel brackets and screwed them to the CC an to the midseat - if I sell the boat once a day (but I think that will never happen ) the new owner could remove the CC and use a tiller engine.

[piperdown]

Sorry for the late reply - I was offline a lomg time. The first I did: I used cardboards to design the dimensions of my CC. I wanted to have good propertion CC to boat and the max space between the sides and the CC. I will take photos with dimensions the next days . You will then be able to copy or to use as an idea how to construct your own one. I first used a CC-design from here and then I cut the cardboard and decreased with the cutter more and more until I was satisfied. To hold the pieces in place i used duct-tape and zip ties .

Hope it helps you a little bit.

Bye
Bernd

Okay, here is the link to the pictures...

https://www.dropbox.com/sh/ob4lv2gp1qx1 ... pDI9a?dl=0

BTW : I made the CC removable - that means, I used stainless steel brackets and screwed them to the CC an to the midseat - if I sell the boat once a day (but I think that will never happen ) the new owner could remove the CC and use a tiller engine.

Wow! Thank you so much! It is greatly appreciated!!

[bernd1]

No problem - thats my understanding of a message board -to help each other.
It would be fine if this would happen all over ther world - a lot would be much easier and less complicated / even more relaxed for everyone.

Keep on build an have fun !

Bye
Bernd

From the south of Germany

Break in time:
https://www.dropbox.com/s/ejvmdepxm5yzr ... 3.wmv?dl=0

Fishing / Boating in France:
https://www.dropbox.com/s/ux7gtzj780vyn ... C.mp4?dl=0

BTW: I never felt unsafe in my GF16 - I had sometimes bad weather and rough conditions with waves of 1,5metre - I just had to slow down and to move very slow - but never one drop of water inside. The best flat bottom boat construction I ever saw.

If you have questions , feel free and send me a message - Cracker Larry helped me a lot too !

[bernd1]

Here is a movie from this summer:
Video summer 2023 with my GF16

[forgeandfruition]

Awesome boat and sweet videos!

Nice work and thanks for posting.