Connecting large molds (CS23)

Power Boats only. Please include the boat type in your question.
Post Reply
User avatar
OffshrAngler
Active Poster
Active Poster
Posts: 317
Joined: Tue Nov 02, 2004 10:57 am
Location: Beaver,PA, Fernandina Beach, FL, OBX, NC

Connecting large molds (CS23)

Post by OffshrAngler »

What is the best was to Connect together molds that need more than a single sheet of ply. Epoxy? I know Capt Hassler did it that way on his CS25.
Top
JASmine
Very Active Poster
Very Active Poster
Posts: 531
Joined: Sun Feb 27, 2005 8:58 pm
Location: Oldsmar, Fl

Post by JASmine »

scabs...a seperate piece of scrap wood used to bridge the two or more pieces of the mold together..use screws
Top
mike neal
Frequent Poster
Frequent Poster
Posts: 21
Joined: Thu Dec 15, 2005 9:08 pm
Location: pensacola fl

Post by mike neal »

I just let the stantions(?) on my strongback hold everything together. Mike
Top
Post Reply

Return to “Power Boats”

Who is online

Users browsing this forum: No registered users and 19 guests