Page 1 of 20
OB17 some assembly required
Posted: Tue Jul 31, 2007 10:22 pm
by JIM M
.
Posted: Wed Aug 01, 2007 12:23 am
by TomW
Jim looking forward to watching the build.
Tom
Posted: Wed Aug 01, 2007 11:23 am
by Lucky_Louis
Way to go Jim, looking forward to following your build. OK TomW, time to get going for you too!
Posted: Fri Aug 03, 2007 5:26 pm
by ross61
Jim,
Where are you at? I am in South Milwaukee. I built an FL14 several years ago (actually for sale now) and would love to watch your progress, and/or lend a hand.
I have considered building this boat, but I just bought a 30 something year old Sea Ray to keep me occupied until I build again.
Ross
Posted: Fri Aug 03, 2007 5:53 pm
by JIM M
.
Posted: Fri Aug 03, 2007 6:09 pm
by ross61
Jim,
There is no email icon on your post. You can email me though and I will get back to you. I work in Mequon, so it's probably not too far from you.
See Ya
Ross
Posted: Fri Aug 03, 2007 6:43 pm
by JIM M
.
Posted: Sun Aug 05, 2007 10:08 pm
by JIM M
Well guys the first weekend went pretty good. We have the strong back done and molds A thru E installed. Also cut transom and clamping board and glued them. Will try to cut and glue stringers this week. Laying out the pieces on ply was easyer than I thought it would be. Will try to start gallery soon.
JIM
Posted: Mon Aug 06, 2007 8:47 am
by tech_support
JIM M wrote:Laying out the pieces on ply was easier than I thought it would be. Will try to start gallery soon. JIM
Once you cut the first couple, it moves very quick.
Posted: Sun Aug 19, 2007 10:21 pm
by JIM M
.