Full transom and BOM for CS25

To help other builders, please list the boat you are building in the Thread Subject -- and to conserve space, please limit your posting to one thread per boat.

Please feel free to use the gallery to display multiple images of your progress.
Post Reply
TL
Frequent Poster
Frequent Poster
Posts: 63
Joined: Wed Dec 31, 1969 7:00 pm
Location: Virginia

Full transom and BOM for CS25

Post by TL »

Do I need to buy an extra piece of 1/2" plywood for the full transom? It appears that the BOM allows for three layers and the clamping board.
The full transom calls for four full layers of 1/2". Can I piece together one of the inside laminations from scrap? Could I use BC Marine Fir for one of the laminations?

Thanks
Top
pushrod58
New Poster
New Poster
Posts: 7
Joined: Wed Jun 09, 2004 1:03 pm
Location: Myrtle beach S.C.

Post by pushrod58 »

If it is going to be glassed over most any type of plywood will work.Don`t think I would use scrap pieces on stern.Need solid pieces glued together for strength.Could probably use the scrap somewhere else like on center console,etc.
Top
User avatar
ddbiiz
Active Poster
Active Poster
Posts: 270
Joined: Sun Aug 03, 2003 1:00 am
Location: USA
Contact:
Contact ddbiiz

Post by ddbiiz »

TL,
post in power boat thread Jacques dosen't answer in this one. 8)

OD18
Don
Top
Post Reply

Return to “Builder's Power Boats”

Who is online

Users browsing this forum: Bing [Bot] and 11 guests