Prep for the letters.
Woods Skoota 32DM
-
- * Bateau Builder - Expert *
- Posts: 10205
- Joined: Tue Jan 12, 2010 12:25 am
-
- * Bateau Builder *
- Posts: 912
- Joined: Tue Aug 13, 2019 3:02 pm
- Location: VA
Re: Woods Skoota 32DM
Getting close when the name is on the back.
Great berth too. I’d crash in it after a few.
I thought the steps were paduak. Walnut, did you say?
Great berth too. I’d crash in it after a few.
I thought the steps were paduak. Walnut, did you say?
-
- * Bateau Builder - Expert *
- Posts: 10205
- Joined: Tue Jan 12, 2010 12:25 am
Re: Woods Skoota 32DM
Ladders are walnut with bordeaux dye. Will use a stain in a week or so.
-
- * Bateau Builder - Expert *
- Posts: 10205
- Joined: Tue Jan 12, 2010 12:25 am
Re: Woods Skoota 32DM
Sanding the hull cabins.
Re: Woods Skoota 32DM
Are you wearing safety glasses while sanding in the hulls??? Jeff
-
- * Bateau Builder - Expert *
- Posts: 10205
- Joined: Tue Jan 12, 2010 12:25 am
Re: Woods Skoota 32DM
I can't see well with specs, so basically, I get a little dirt in the eyes. I do wear safety glasses or a faceshield for metalwork, but I tried it in here and the damn thing won't stay on, tips over.
I got one done, touch ups and the other hull cabin to sand still. Yuko!
- glossieblack
- * Bateau Builder *
- Posts: 4107
- Joined: Wed Jan 02, 2013 1:28 pm
- Location: Australia
Re: Woods Skoota 32DM
Looking good. Do you have the standing and running rigging ready to install?
Currently building Jacques Mertens ST21 "Skinnydip". Boating adventures: Splash testing and using 'Skinnydip, as a basis of further building refinement; Adams 44’ sailing sloop "Great Sandy" (cruising and maintaining); Iain Oughtred Feather Pram "Mini Dip" (building); Jacques Mertens R13 "Wood Duck" (built and due for maintenance).
-
- * Bateau Builder - Expert *
- Posts: 10205
- Joined: Tue Jan 12, 2010 12:25 am
Re: Woods Skoota 32DM
Powerboat only. I wish I had a small sail in case I ran out of gas, but it'd only go downwind or reach.0glossieblack wrote: ↑Fri May 20, 2022 6:39 pm Looking good. Do you have the standing and running rigging ready to install?
-
- * Bateau Builder - Expert *
- Posts: 10205
- Joined: Tue Jan 12, 2010 12:25 am
-
- * Bateau Builder - Expert *
- Posts: 8942
- Joined: Tue Aug 02, 2011 4:23 am
- Location: Kasilof, Alaska
Re: Woods Skoota 32DM
Some form of sail assist is starting to look a lot better now for some reason Be a shame to get that thing finished and then have to go rob a bank to fuel it up
Who is online
Users browsing this forum: No registered users and 0 guests