Page 1 of 1

Has anyone tried this C&c router?

Posted: Sat Feb 01, 2020 8:02 am
by Masoric
Has anyone tried this $500 4x8 c&c router?

Seems like it has a small margin of error compared to professional units. But for the main construction method here that might not be an issue.

https://www.maslowcnc.com/

Re: Has anyone tried this C&c router?

Posted: Sat Feb 01, 2020 9:26 am
by fallguy1000
I saw it, but at the end of the day, it seemed easier to draw lines and run a router by hand.

Re: Has anyone tried this C&c router?

Posted: Sat Feb 01, 2020 10:55 am
by Jaysen
Know a guy that has one. The problem for us would be the edge cuts. It tends to get “wobbly” in the edges. Other than that he loves it.

His solution to the edge issue is to just stop his plans 1” from the edge.