PG25 Motor Well Sides & Stringer Question
Posted: Sat Sep 18, 2021 11:45 am
Good morning,
According to plans and some pictures there is approximately a 1" gap or space between the stringers and the motor well sides.
See the pictures below from a previous builder:
https://www.community.boatbuildercentra ... 75%20s.JPG
https://www.community.boatbuildercentra ... 85%20s.JPG
My question is how do you get down in there to fillet and glass the inside of the motor well side to the hull bottom?
Or just leave it alone?
Would it be beneficial to shrink the splash well opening width and bring the motor well sides in so they are flush to the stringers?
Epoxy them to the stringers to act as knees?
Assuming engine clearance would still be sufficient.
Thanks,
Serge
According to plans and some pictures there is approximately a 1" gap or space between the stringers and the motor well sides.
See the pictures below from a previous builder:
https://www.community.boatbuildercentra ... 75%20s.JPG
https://www.community.boatbuildercentra ... 85%20s.JPG
My question is how do you get down in there to fillet and glass the inside of the motor well side to the hull bottom?
Or just leave it alone?
Would it be beneficial to shrink the splash well opening width and bring the motor well sides in so they are flush to the stringers?
Epoxy them to the stringers to act as knees?
Assuming engine clearance would still be sufficient.
Thanks,
Serge