Sanity check!
Sanity check!
If I have stbd sides on top- tracing it like I have it laid out will produce port side if I just flip the panels over right??? I think I might be going crazy! Not trying to waste 3 pieces of plywood. Lol
Re: Sanity check!
For straight sections yes, for curved sections probably, not sure check your plans. Tom
Restored Mirror Dinghy, Bought OD18 built by CL, Westlawn School of Yacht Design courses. LT US Navy 1970-1978
- BarraMan
- * Bateau Builder - Expert *
- Posts: 2164
- Joined: Tue Dec 11, 2012 3:44 pm
- Location: Australia
Re: Sanity check!
In a word - Yes! ( If I have understood your question correctly)
-
- * Bateau Builder *
- Posts: 2433
- Joined: Tue Jun 07, 2016 6:55 pm
- Location: Bush Alaska
- Location: Bush Alaska
Re: Sanity check!
Yes that will work. You can also save a second tracing by clamping two sheets together and cutting them together from the first set of lines you draw out.
Re: Sanity check!
Thanks everyone! I was going crazy for about an hour… the half pot of coffee didn’t help. Moving along good now!
Re: Sanity check!
One place to be careful is when scarfing or butt joiinting the bottom panels or side panels: dont make 2 left sides! If scarfing not an issue but a butt block on the outside of the boat is going to get some looks.
There are only two seasons in Vermont: boating season, and boat-building season.
Completed Paul Butler 14' Clark Fork Drifter
Completed Jacques Mertens FS14LS + 10%, Build Thread
Started Iain Oughtred Tammie Norrie
Completed Paul Butler 14' Clark Fork Drifter
Completed Jacques Mertens FS14LS + 10%, Build Thread
Started Iain Oughtred Tammie Norrie
Who is online
Users browsing this forum: No registered users and 13 guests