AR15 Rigging Question
Posted: Thu Feb 03, 2022 1:43 pm
Jacques,
This question came in from a customer who is building the AR15.
I'm working on an AR-15. I contacted Dwyer about the mast and rigging and they had a couple of questions that I hope you can answer for me.
First, the measurement on the length of the spreader arm is listed on the plans as 25 7/8. I'm assuming that is a horizontal measurement and the actual length of the arm is approximately 27 7/8 - could you confirm this?
Then, they were unsure from the plans where the headstay and shroud locations on the mast were. If I understood correctly, they have an all-in-one part DH 856A where all of these and a trapeze could join the mast.
Thank you!
Reid
This question came in from a customer who is building the AR15.
I'm working on an AR-15. I contacted Dwyer about the mast and rigging and they had a couple of questions that I hope you can answer for me.
First, the measurement on the length of the spreader arm is listed on the plans as 25 7/8. I'm assuming that is a horizontal measurement and the actual length of the arm is approximately 27 7/8 - could you confirm this?
Then, they were unsure from the plans where the headstay and shroud locations on the mast were. If I understood correctly, they have an all-in-one part DH 856A where all of these and a trapeze could join the mast.
Thank you!
Reid